The new Alinco DJ-160 Radio will receive between 137-174 Mhz, and transmit in the 2Meter band only (144-148Mhz). A simple modification to the radio will enable it to transmit in the full range it receives currently. I have not tested the output power on other frequencies (Due to my one and only watt meter getting fried) however I have tried setting a weather receiver a small distance away, and I did hear the radio in the receiver. To make the mod, the following must be done: (I assume that you have some experience with electronics and that you can tell a wire from a resistor, from a transistor) 1) Take the battery of the radio by lifting the battery release button. If you look at the bottom of the radio, there will be a metal plate that is held on with 4 small screws. Take this plate off, noting exactly how the clip was held on (like the slot for the battery release clip) 2) On the back of the radio there are two screws that hold the back of the radio on, take these screws out. 3) Now you should be able to lift the bottom part of the radio by the battery release button slightly apart. I was told that you should take the top knobs off, but I found that I didn't have to. 4) If you take the Battery Release Button and turn it about 90 degress, the button should come out easily. After you get the small piece of plastic that is the button, you should see a yellow wire behind where the clip was. 5) Take a small wire cutter and CUT this YELLOW wire. You should probably make sure that the wire doesn't have bare metal showing from a lousy cutter, because I don't think that grounding this wire to the case would be HEALTHY for your radio. :-) 6) After You cut this wire. Assemble the radio, and just before you turn on the radio, do a power reset by holding the FUNC button while turning on the radio. This will reset the radio to ALL of the factory set parameters. YOU WILL LOOSE PROGRAMMED FREQUENCIES that were programmed into the memory mode of the radio, so just write the frequencies down before proceding with the above instructions. 7) The radio should be just like new, except that the transmit will be enabled for ALL frequencies! GOOD Luck! If you use these mods for ILLEGAL purposes, pity upon thy sole, for you do not belong in the ranks of Amateur Radio. This information is only supplied for Legal and Informational Purposes only and I can NOT be held responsible for anything that you do with this INFO. And if you screw up your radio, TOO BAD. I can't be held responsible. Name: Donald L. Schleede Call: KB2LZF ====================================================================== Note: I haven't tried or verified this, proceed at your own risk. Do not do this mod unless you have a legal and good reason, like being in MARS, or to drive a transverter. Do not transmit outside of legal bands. I don't have any info beyond what is above, sorry. WA2ISE /EX