copied from packet: From: n2fwq@wb2gtx.nj.usa.na (DANIEL) To: mods@allbbs Subject: ft5200 crossband mods Tony Lessing KA3KVD 76474,2051 Ken Hoehn/N8NYO [SysOp] 73670,3622 the mod for the FT5200 cross band mod. It goes as follows: 1. Disconnect DC power from radio. 2. Unlatch and remove the front control head. !Do not take apart the control head or the warranty will go *VOID* :-) 3. Remove (6) screws from top cover of radio. 4. Remove (6) screws from bottom cover of radio. 5. Remove top and bottom cover.. being careful of the speaker that will want to fall out. 6. Remove the (2) silver screws (on each side of radio) holding front control head mounting plate to main body of radio. Remove the front mounting plate. 7. Locate and unsolder jumper pad 17. 8. Install the front mounting plate, and top and bottom covers. 9. Reconnect power.... you're ready to go.. 10. To put in xband repeat press and hold the RPT key while turning on the radio. To stop... turn off the radio. !! note !! It is suggested to disconnect the mic when in xband repeat, as it will be "hot". Adjust the volume knob for the desired repeat audio level. Cheers, de Tony - KA3KVD There is 1 Reply. Regarding .... Jumper Pad 17 .... This might seem confusing when first viewing the jumper pads... they are to the right of the 5_strip connector for the face plate and are numbered as follows .. 20 18 16 14 12 10 8 6 4 2 .. 19 17 15 13 11 09 7 5 3 1 You will see that the number 17 is lower than the rest and that there are 2 pads above it... one in line with all the others (this is the correct one) and one that is horizontal and just above the number "17" (this should be left alone) 73 ... Tony I tried it...it works! It is a bit rough cross-band repeating two repeaters (hardly efficient use of spectrum, now isn't it? (Honest..just testing) Also, there are certain frequency combinations that just don't work, and others that require one, the other, or both sides to transmit at low power. Nice toy...now, a practical application??? Ken :) ----------------------------------------------------------------------------- Note: I haven't tried or verified this, proceed at your own risk. WA2ISE