copied from the Internet: From: ag684@cleveland.Freenet.Edu (Mark Stephany) Newsgroups: rec.radio.shortwave Subject: Re: Mods for PRO-43 This is what I've got on the Pro-43, not my words. PRO-43 A few people have mentioned the cellular mod for the PRO-43; it turns out you should not remove but MOVE the diode. Doing so allows cellular coverage as well as low band (up to 88 MHz) coverage. PRO-43 Cellular Frequency Restoration and Low Band Expansion Note: It is not lawful to monitor cellular or conventional mobile telephone conversations. The following procedure requires familiarity with microcircuit soldering and will violate your warranty. Grove Enterprises assumes no liability resulting from its attempt, nor will accept the modified scanner for return under any condition. TOOLS NEEDED: Fine point, low power soldering pencil; solder wick or a desoldering tool; pointed awl, hemostats or pointed tweezers; small Philips screwdriver; solder. 1) Remove the battery, antenna and back cover (held in place by four screws). 2) Remove the six screws holding the top circuit board in place. Carefully unsolder the two antenna connections from the board. Bend the antenna ground tab fully up from the board. Carefully lift the board, unplugging the black connector at its base, and lay the board out of the way on its bundle of colored wires. 3) Remove the two screws from the next board and lift it, carefully unplugging the white connector at the bottom of the board. Lift it up and lay it aside on its brown wire (which can be unplugged if necessary). 4) Unsolder and remove the metal shield from the final board, revealing the microprocessor; note the row of diodes labeled D1-D5 above it. Only diodes D1, D2, and D4 are present; assisted by a pointed tool, unsolder and remove D4, the lone diode (this restores cellular frequencies which will be searched in 30 kHz steps). 5) Resolder the removed diode carefully into position D3 to extend low band coverage to 88 MHz. 6) Reassemble the boards, paying particular attention to the alignment of the plugs. Test the radio by entering any frequency between 870 and 890 MHz (cellular) and 51-88 MHz (low band). ============================================================================= Note: I haven't tried or verified this, proceed at your own risk. WA2ISE